Generally small and medium-sized packaging, such as beer, beverages, fruit and other food cartons, more and more products using white paper for color printing. The preprinting process of the carton is much better than the quality of printing directly with corrugated cardboard. However, as with other printing processes, it is also not possible to print various cartons or cartons and paper bag products with an offset or letterpress printer. Avoid some quality problems. Therefore, correct understanding and understanding of several fault phenomena in the printing process, and good printing operations and process technology, in order to better improve production efficiency and product quality.

First, the problem of ink stick caused by unsatisfied printing pressure:

When the bearing of the blanket cylinder is seriously worn, due to excessive roller separation, the surface of the cylinder is caused to slide and cause ink mark marks. This is a situation; the second case is due to the use of a hard lining, embossing In the process, ink sticks are caused by the sliding phenomenon; in the third case, the roller gears are worn badly, and the center distance of the drum is too large, so that the backlash of the gears is too large, so that the gears vibrate after the drums are pressurized, and the sliding friction occurs on the drum surface. The fourth situation is that the pressure between the plate cylinder and the blanket cylinder is too large, so that the blanket is squeezed to form a large frictional slide, which causes the longitudinal deformation of the screen surface to expand and cause ink bars. The above situation shall be achieved by replacing the roller bearing, adjusting the characteristics of the packing material, and reducing the center distance of the roller, so that the meshing backlash of the gear is less than 0.1mm; according to the specification of the equipment, the thickness of the packing shall be set to avoid the occurrence of excessive pressure. To prevent the phenomenon of ink bars.

one two three four five six seven eight nine

Welded Wire Mesh Gabion

Welded Gabion Box (baskets), also known as welded stone cage, are made of Welded Wire Mesh panel. Welded gabion baskets can be connected with other similar containers and filled with stone to form flexible and permeable structures for retaining of riverbank and soils.This kind of wire mesh containers are uniformly welded and can be supplied of various sizes.

welde wire mesh gabion

gabion wall

Characteristics
(1) Economic:just fill the stone into the Gabions and seal it
(2) Simple installation: no special technology needed
(3) Weather proof under natural destroy, corrosion resistant
(4) No collapse even under big scope of deforming
(5) Sludge in the stones is good for plant growing
(6) Good permeation can prevent the damage by hydrostatic
(7) Less transport freight. It can be folded together for transport and further installation

Finishing

Ÿ(1) Heavily galvanized

Ÿ(2) Galfan coated (95% zinc + 5% aluminium)

Specification

Mesh Size/ cm
Body Size (L x B x H/ mm)
Wire diameter/ mm

10 x 10

10 x 5

8.3 x 10

500 x 500 x 250

500 x 500 x5 00

1000 x 500 x 500

1500 x 500 x 500

2000 x 500 x 500

3000 x 500 x 500

1000 x 1000 x 250

2000 x 1000 x 250

3.5

4.0

4.5

Welded Panel For Gabion,Hot Dipped Galvanized Gabions,Aluminum Gabions

DINGZHOU TIAN YILONG METAL PRODUCTS CO., LTD. , https://www.wiremeshsolution.com

February 23, 2024