Centrifuge separation technology notes:

1. Usually, the centrifuge will have a registration form, please register it correctly before use (user, rotor, speed, time).

2. The centrifuge tube must be well balanced. Pay attention to the position balance when placing the rotor. Never exceed the maximum speed of the centrifuge or rotor.

3. Be sure to leave the centrifuge after reaching the preset speed; if there is any abnormality, stop immediately.

4. Usually you can hear the sound to know if the centrifugal condition is normal, and you can also pay attention to the vibration of the centrifuge.

5. After using a sample of high salt solution such as ammonium sulfate, be sure to wash the rotor and clean the centrifuge chamber.

6. Ultra-high speed centrifuges are extremely high in speed and more complex, requiring additional specialized training before they can be used.

Centrifuge separation technology use steps:

Usually register before using the centrifuge, please develop registration habits.

1. After setting the operating temperature (usually 4 °C), first place the rotor into the centrifugal chamber, pay attention to the rotor to clamp the shaft; close the door, the temperature of the centrifugal chamber begins to drop, and the pre-cooling time should be sufficient.

2. Put the sample into a suitable centrifuge tube, balance the weight with both balances, cover the centrifuge tube and tighten.

â—† Note that the centrifuge tube is only 70% full. Although it is covered, it may leak out due to too strong centrifugal force.

â—† Most of the centrifuge tubes are covered with a lid. Note that the lid of the tube should be balanced.

â—† Centrifuge tubes are usually placed on crushed ice. When removing the balance, wipe off the ice-crushing liquid.

â—† The centrifuge tube that is placed in the order should be equilibrated with another centrifuge tube filled with clean water.

3. Place the well-balanced centrifuge tube symmetrically into the rotor and cover the cover of the rotor, taking care to check for tightness.

â—† If the cover of the rotor is not tightened, it will fall out during centrifugation, causing great damage!

4. Close the centrifuge door and adjust the required speed and time on the dashboard.

High Quality Series Caster

High Quality Series Caster

High quality series caster

Ningbo Mywin Caster Co., Ltd. , https://www.mywin-caster.com

August 28, 2021